Meeting Date: 
Sun, 10/10/2010
Start and End Time: 
12:30 - 5:30 pm
Personnel Present: 
Personnel Present: 
Personnel Present: 
Personnel Present: 
Personnel Present: 
Tasks This Meeting: 

- Build hand

- Test prototype board sensors

Reflections For This Meeting: 

The season is too short.

The prototype board is amazing.

Today Gavin worked on the prototype board for controling the POT and the magnetic sensor.  Karl and Al worked on bending and cutting the plastic for the hand and wrist.  It looks like the prototype board is going to be extreme helpful on the movement of the stance and arm.

The robot seems to balance pretty well

The basic design of the plastic cut out of the hand

Laying the plan on the polycarb sheet


Cutting the polycarb for bending\

Al cutting the polycarb for the hand

A closeup of cutting the plastic for the hand

Final cuts on the polycarb

Gavin working with the breadboard for the pedometer 

Testing the sample program

Al and Karl working on the hand

Bending the plastic

Rough hand design

The rough bends for the hand